You are here:
News
News
Steam quenching of the Stuffing box 2010-12-21
For the process pumps in a refinery, where high temperature process fluids are used ( 260 deg C and upto 340 Deg C) , one of the pump vendor is requiring LP steam quenching in the stuffing box in thei
reservoir mixing? 2010-12-21
Do you have any tips for the best way to promote mixing in a potable water reservoir?
General P&ID Review Recommendations 2010-12-21
I'm in a position now where I'm reviewing P&ID's for vendor-supplied equipment. In the past I've been in Operations where I merely updated these types of drawings.
Velocity through check valve - max and min 2010-12-20
A supplier brought to my attention that I had an unusually high velocity going through a check valve in a PS design I was working on...
Variable displacement pump, accumulator and Rotary actuator 2010-12-20
I am using Matlab's simhydraulics to design a closed loop hydraulic circuit using a variable displacement pump and a gas charged accumulator to drive a rotary actuator.
Butterfly valve downstream of a check valve, will it work. 2010-12-20
I am laying out some additons to a existing Natrural Gas compressor station and I am tight on space. To save space I am trying to put a butterfly valve directly downstream of a wheatly swing check val
Smokey's Hot Vapor Engine 2010-12-17
In my research of Smokey's engine Something Has struck me that no one seems to metion. When the air/fuel mixture is heated up past the Turbo (check valve), a lot of pressure is created down stream .Wh
Highest Compression Ratio for E85 2010-12-17
What is the highest compression ratio that E85 is able to run at without undue harm? What are the chances that the automotive manufacturers will make a car that can only run on E85, and gain power by
