You are here:
News
News
Maximizing Vacuum on ITB setups 2010-12-16
I just solved what I thought was (is) a concern when trying to tune individual throttle body setups with only a MAP / Speed Density ECU with no alpha N.
Wafer Check Valve Details 2010-12-16
We have a few wafer check valves manufactured by Mission Valve and Pump. We do not have any information on these items. I tried locating the company via the internet - but had no luck.
Use of Solenoid Valve in Heat Pump Liquid Line 2010-12-16
Carrier Residential Heat Pumps specify that if lines are longer than 90ft that a bidirectional solenoid valve be placed in the liquid line near the outdoor unit to eliminate refrigerant being able to
Twincharging with Screw-Type SC instead of Roots 2010-12-15
Twincharging an engine that features a screw-type supercharger (ie it already has internal compression) in my mind has the following advantages and disadvantages:
Non-Invasive Accumulator Pre-Charge Pressure Check 2010-12-15
Normally it takes a lot of time and equipment to check a hydraulic accumulators gas precharge pressure. Also using the normal way of opening the gas charge valve and reading Gas pressure at the Accumu
Minimum dry vacuum or minimum suction lift of a vane pump 2010-12-15
I have some questions with regards to a diesel pumping application. I am using a vane pump to suck fuel out of a main storage horizontal tank.
Flow delay method 2010-12-13
I am looking for a method about delay device in fluid system, the fluid is incompressible. I have oscillatory flow and this flow will be divided to two flow by Y joint, I want to have a delay for one
Water Lubricated vertical turbine pump 2010-12-13
Is it necessary for water lubricated vertical turbine pump line shaft bearings be immersed in water prior to starting the pump?
